How We Repair Your SPX Cooling Tower
Air conditioners, mini-splits, window units, evaporative coolers and chillers move heat out using compressors or water evaporation, fans and controls.
SPX Cooling Tower models often use model-specific control boards, sensors and diagnostic modes. We look up your exact model number so the right part goes in the first time.
Common Cooling Tower Problems We Fix
Blowing warm air
A failed capacitor or contactor, low refrigerant, a dirty coil or a compressor problem.
Not turning on
A thermostat, fuse, breaker or control board issue.
Water leaking indoors
A clogged condensate drain or a failed condensate pump.
Ice on the lines or coil
Low airflow from a dirty filter or a refrigerant problem.
Swamp cooler not cooling
Dry or worn pads, a failed water pump or float valve.
Quick Checks Before You Call
These are safe for most owners and sometimes solve the problem without a visit:
- Replace or clean the air filter
- Check the thermostat mode and batteries
- Clear leaves and debris around the outdoor unit
Still not working? Call (844) 442-1500 or try our troubleshooting wizard.
Our 5-Step Repair Process
- Call or book onlineTell us what your SPX cooling tower is doing and when it started. We schedule the first available visit, with priority for equipment that is stopping your business.
- DiagnosisThe technician checks power, controls and the parts most likely to fail, using the model's service data and test modes.
- Upfront quoteYou get the cause, the repair and the price before any work starts. If repair does not make sense, we tell you.
- RepairWe install original or equivalent parts matched to your model and clean up when we are done.
- Test and warrantyWe run the appliance through a full cycle to confirm the fix. The repair is covered by our 90-day parts and labor warranty.
Parts We Replace Most Often
- Capacitors
- Contactors
- Fan motors
- Condensate pumps
- Control boards
- Evaporative cooler pads and pumps
Cost and Lifespan
Most cooling tower repairs cost $150–$600 including parts and labor, and these appliances typically last 10–15 years. These are national estimates: your exact price comes after the diagnosis. Use the repair vs replace calculator to compare.
Keep It Running Longer
- Clean coils yearly
- Flush condensate drains each spring
- Change filters every one to three months
Cooling Tower Repair in Pennsylvania
We repair cooling towers in 693 cities and towns across Pennsylvania. Humid summers and long, cold winters in Pennsylvania give homes across the state appliances a busy year, with heavy indoor use from fall to spring.
Frequently Asked Questions
How much does SPX Cooling Tower Repair cost in Pennsylvania?
Most cooling tower repairs fall between $150–$600 including parts and labor. The final price depends on the part that failed and your model. You get an exact quote after the diagnosis and before any work starts.
Can you repair my cooling tower today?
Same-day visits depend on technician availability in Pennsylvania. Call (844) 442-1500 early in the day for the best chance of a same-day or next-day appointment.
Is the repair guaranteed?
Yes. Parts and labor are covered by our 90-day warranty. If the same problem comes back within that time, we return and fix it.
Do you work on all SPX models?
We repair current and older SPX models. Some discontinued parts can be hard to find; if that is the case for your model, we tell you before you pay for a repair.
Should I repair or replace my cooling tower?
A cooling tower typically lasts about 10 to 15 years. If yours is well inside that range and the repair costs less than half the price of a new one, repairing usually makes sense. Near the end of its life, or when the repair costs more than half of a replacement, replacing is often the better value. We give you an honest opinion either way.