How We Repair Your Tunnel Washer
Washing machines fill, agitate or tumble, drain and spin using valves, a pump, a drive motor and suspension, all managed by a control board.
Common Tunnel Washer Problems We Fix
Will not start
A door lock fault, a control board problem or a failed lid switch.
Loud grinding or roaring
Worn tub bearings, usually on front-load machines.
Bad smell
Mildew in the door gasket, drain filter or detergent drawer.
Will not drain or spin
A clogged drain pump filter, a kinked drain hose, a failed drain pump or a lid or door lock that is not engaging.
Leaking
A worn door boot seal on front-loaders, a loose or cracked hose, or a failing tub seal or pump.
Shaking or walking during spin
An unbalanced load, worn shock absorbers or suspension springs, or a unit that is not level.
Quick Checks Before You Call
These are safe for most owners and sometimes solve the problem without a visit:
- Clean the drain pump filter (front-loaders usually have a small door at the bottom).
- Make sure both water valves are open and hoses are not kinked.
- Redistribute heavy loads and check the machine is level.
- Write down any error code.
Still not working? Call (844) 442-1500 or try our troubleshooting wizard.
Our 5-Step Repair Process
- Call or book onlineTell us what your tunnel washer is doing and when it started. We schedule the first available visit, with priority for equipment that is stopping your business.
- DiagnosisThe technician checks power, controls and the parts most likely to fail, using the model's service data and test modes.
- Upfront quoteYou get the cause, the repair and the price before any work starts. If repair does not make sense, we tell you.
- RepairWe install original or equivalent parts matched to your model and clean up when we are done.
- Test and warrantyWe run the appliance through a full cycle to confirm the fix. The repair is covered by our 90-day parts and labor warranty.
Parts We Replace Most Often
- Drain pump
- Door lock or lid switch
- Door boot seal
- Water inlet valve
- Shock absorbers and springs
- Drive belt and motor
- Tub bearings
- Control board
Cost and Lifespan
Most tunnel washer repairs cost $150–$450 including parts and labor, and these appliances typically last 10–14 years. These are national estimates: your exact price comes after the diagnosis. Use the repair vs replace calculator to compare.
Keep It Running Longer
- Replace rubber fill hoses with braided ones every five years
- Leave the door open between loads
- Use HE detergent in the right amount
Tunnel Washer Repair in Pennsylvania
We repair tunnel washers in 693 cities and towns across Pennsylvania. Humid summers and long, cold winters in Pennsylvania give homes across the state appliances a busy year, with heavy indoor use from fall to spring.
Frequently Asked Questions
How much does Tunnel Washer Repair cost in Pennsylvania?
Most tunnel washer repairs fall between $150–$450 including parts and labor. The final price depends on the part that failed and your model. You get an exact quote after the diagnosis and before any work starts.
Can you repair my tunnel washer today?
Same-day visits depend on technician availability in Pennsylvania. Call (844) 442-1500 early in the day for the best chance of a same-day or next-day appointment.
Is the repair guaranteed?
Yes. Parts and labor are covered by our 90-day warranty. If the same problem comes back within that time, we return and fix it.
Which brands of tunnel washer do you repair?
We repair all major brands. See the brand list on this page, or call with your model number and we will confirm.
Should I repair or replace my tunnel washer?
A tunnel washer typically lasts about 10 to 14 years. If yours is well inside that range and the repair costs less than half the price of a new one, repairing usually makes sense. Near the end of its life, or when the repair costs more than half of a replacement, replacing is often the better value. We give you an honest opinion either way.